-
dblalark@yahoo.com
Problem posted by dblalark@[email protected] on May 8, 2008
how to program the remote
-
Manual
Problem posted by buzz_gurl18@[email protected] on May 7, 2008
I just bought a camero with this system. All i need is the Manual. Thank you
-
romte start
Problem posted by mcguirea@[email protected] on May 7, 2008
not able to use remote start not manual
-
Car Alarm
Problem posted by steamfitter4@[email protected] on May 6, 2008
Need Manual for this system
-
need help
Problem posted by theshiznit_01@[email protected] on May 5, 2008
i just replaced heater core in my 97 Chevy Blazer and now i put my dash back togetherand my Alarm no longer works
-
Instructions on how to clear memory for new remote
Problem posted by jmorytko@[email protected] on May 5, 2008
system will not receive second remote need to clear system for system to receive new remote
-
picture of remote
Problem posted by mbrinlee1@[email protected] on May 3, 2008
can't figure out the display on the remote
-
user manual and installation instructions
Problem posted by satpaljassal@[email protected] on May 3, 2008
the wires of the alarm were cut by some electrical techanician and i want to join and set all right in position
-
sensor
Problem posted by ninjafirst1@[email protected] on May 3, 2008
lost sensor
-
central
Problem posted by ma_ni_lu@[email protected] on Apr 30, 2008
i get this alarm from my friend
-
circurt diagram drawing
Problem posted by puluk_leepee@[email protected] on Apr 29, 2008
I want to install to another car
-
wiring diagram
Problem posted by monte3018@[email protected] on Apr 28, 2008
Have a Clifford Supernova II on a vehicle that I need to replace with another system, but have no indicators as to what wiring goes to where. Looking for a diagram on the Clifford to disconnect everything
-
lost remote
Problem posted by ciarafrench@[email protected] on Apr 24, 2008
i lost the remotes to my car and i can't turn the alarm off which means my car will not start. I would like to know what i can do to get another remote or get the alarm takin out my car. i have ben havin problems with it since i received the car wen i had the remote sometimes it still wouldn't…
-
i dont know hau to use.
Problem posted by aiselahaxhiu@[email protected] on Apr 21, 2008
i dont nou know to use.my car is blocked.
-
i dont know hau to use.
Problem posted by aiselahaxhiu@[email protected] on Apr 21, 2008
i dont nou know to use.my car is blocked.
-
Alarm system
Problem posted by mandyj@[email protected] on Apr 20, 2008
Everything works as its supposed to except the alarm does not beep when you arm and dissarm it. How do i fix this problem.
-
wiring diagram
Problem posted by bladeballa27@[email protected] on Apr 18, 2008
Im in need of a wiring diagram as im trying to remove my current alarm and placing it on another car. Diagram needed is (pro9801)
-
sigma alarm siren
Problem posted by rainbowmo@[email protected] on Apr 12, 2008
Iwant to stop my alarm siren. what if I just cut the wire going into the sigma alarm immobiliser AS ONE CAR REPAIR MAN TOLD ME? IT DOES NOT HAVE TYPE NUMBER 1998 RENAULT MEGAN BUILT IN. i START MY CAR BY PUTTING THE BY PASS NUMBER AN IN THE MEANTIME THE SIREN STARTS AND WAKES UP EVERYONE.…