-
how can I change the oil
Problem posted by freds.5@[email protected] on May 16, 2008
m65225
-
engine not found
Problem posted by lawrence.wagoner@[email protected] on May 16, 2008
my lth135 has a kohler command13HD engine and I can't find manual/parts
-
problem re-starting
Problem posted by movahedis@[email protected] on May 15, 2008
Used the brandnew 321 EL Chinsaw for the first time a couple of days ago.
The chainsaw was working fine. It suddenly stopped working. Thought it may have been due to low oil level causing overheating. Once the machine was cooled down, I expected it to re-start, but still not working. Any ideas??
-
oilier
Problem posted by ace13733@[email protected] on May 14, 2008
i dont know how to adjust my oilier because im getting little to no oil to my bar and chain.
-
Blades
Problem posted by johninwaterford@[email protected] on May 12, 2008
Blades will not disengage so are always going regardless of the position of the blades lever.
-
Shute clogs up
Problem posted by wmcharg@[email protected] on May 12, 2008
Is there any tricks of the trade to stop grass from clogging at the opening of the mower deck and not getting getting to the three buckets. I bought the one recommended for the tractor model. Thanks
-
Husqvarna brush cutter
Problem posted by fred@[email protected] on May 12, 2008
Is there a manual for this model?
Any help would be appreciated.
Thanks
-
New chain installation
Problem posted by jasperlake@[email protected] on May 11, 2008
With difficulty removed drive cover and with new chain installed can't get cover back on....because of the spring clip circumference. What am I doing wrong?
-
runs rough, low power, stalls
Problem posted by ajbrowning2000@[email protected] on May 10, 2008
Started happening recently. Once the mower warms up it starts surging and then cuts with very low power. When I move the lever to the off position, it doesn't shut off. There's a little loop of cable sticking out at the engine end that I push and then it shuts off.
-
mower deck belt
Problem posted by donnawv29@[email protected] on May 9, 2008
would like to get a diagram on how to put the belt back on
-
Lawn Tractor quit pulling hills
Problem posted by msvee71@[email protected] on May 4, 2008
I have 25 hours on this lawn tractor. It worked fine pulling hills last summer. It suddenly and without warning, stopped. It will start up the hill and then slowly stop on the hill and make a shuttering sound that sounds like it's coming from the idler pullies. If I put the transmission into…
-
hat hoop
Problem posted by sbfamily1@[email protected] on May 3, 2008
I have a viking designer 1 and I have a hat hoop but no information as to how to use it
-
Blades won't engage
Problem posted by lisabrak@[email protected] on May 3, 2008
The blades will not engage. I have replaced to PTO swithc and the relay assembly and still not working. The pullys move freely and belt okay. The belt up high seems to be loose and the pully doesn't move. However this pully is not attached to the mower deck.
No loose wires although there…
-
won't start!
Problem posted by ahamptonathome@[email protected] on May 3, 2008
won't start. Replaced switch and had battery charged. Yesterday it at least had working headlights - now they won't come on. Ideas? Help?
-
+
Problem posted by rgrandall1954@[email protected] on May 3, 2008
-
operation manual
Problem posted by ansel41@[email protected] on May 1, 2008
Tractor came with house and it has no paperwork at all. I have been able to buy parts OK just can't seem to adjust the deck.
-
Deck Belt
Problem posted by jay@[email protected] on May 1, 2008
I bought it used and am unsure of the year it is.
I need a deck belt.
Anyway to be sure of what year the rider 155 is?
Thanks
Jay
-
mower
Problem posted by dmanbluz@[email protected] on Apr 30, 2008
When the electric clutch is engaged the motor will die. All this happened after I mowed the lawn. When i went otput the mower in the shed, the starter would not engage and i had to jump the starter terminals to get it started. After getting it started, iengaged the mower clutch and that/s when…
-
carbraitor adjustments
Problem posted by bowringw@[email protected] on Apr 29, 2008
too much fuel flooding out
-
mower
Problem posted by kleenkar1@[email protected] on Apr 27, 2008
will not start no spark
-
Mower will not always start
Problem posted by ksl.924@[email protected] on Apr 26, 2008
My Husqvarna riding lawn mower will not always start. I have the break engaged, the blade off and it will just click. This happens after I have been mowing awhile, and I know that there is plenty of gas and the battery is okay. Any one else have this problem. Is there a solution?
-
help
Problem posted by wrigj@[email protected] on Apr 24, 2008
I don't know to air bleed the hydro gear rear
-
Need help installing drive belt
Problem posted by jgreen3605@[email protected] on Apr 23, 2008
Need help installing drive belt
-
Starting
Problem posted by sum2hunt@[email protected] on Apr 23, 2008
After running the saw for about ten minutes it died and I could not restart. Acts as though it is not getting a spark.
-
Transmission Problems
Problem posted by kd4sdu@[email protected] on Apr 22, 2008
after mower sits for a week, doesn,t want to move. Also Transmission is noisy and mower very slow mowing up hill. Very dissappointed with autotransmission.Any help would be appreciated. Ken
-
Transmission Problems
Problem posted by kd4sdu@[email protected] on Apr 22, 2008
after mower sits for a week, doesn,t want to move. Also Transmission is noisy and mower very slow mowing up hill. Very dissappointed with autotransmission.Any help would be appreciated. Ken